Automotive Insulation

Garage Door Insulation

Want to eliminate draughts through your garage door? Low-E Garage door insulation increases R-value, reflects 97% solar gain, stops draughts, and offers moisture protection. It is the quickest and easiest way to insulate and finish off any garage door.

Request a free sample See how it is installed

Reflects 97% of Radiant Heat
Deadens Sound
Won't Absorb Moisture
Mould and Fungi Resistant
Quick and Easy to Install

Installation

How to Install Garage Door Insulation

Whether you want to reduce heating costs in your home or make good use of your garage space, properly installing the right type of insulation is key to it’s effectiveness.

Carefully follow each of the steps below and you will soon have a well-insulated garage door and improve the comfort in your home. Take care when using sharp blades and always refer to manufacturers guidelines.

Clean the Garage Door
Clean down the garage door with a damp cloth to remove any dust that may have settled. Pay extra attention to removing dust from the struts of the garage door as these will be the main contact points for adhesion and any dust will keep the tape from holding.
Apply Double Sided Tape to the Struts
Apply double sided tape to the struts of the garage door making sure to cover the whole frame. At this point, don’t remove the paper backing on the exposed face of the tape.
Apply Pressure to Seal
Using your hand or a plastic squeegee, apply pressure to the double sided tape all the way around the frame to make sure it is securely fixed.
Peal off the Paper
Remove the protective paper to expose the sticky face of the tape.
Secure the Insulation
Carefully roll the insulation out and apply pressure to secure it to the double sided tape.
Cut Out for Hinges
Cut out the insulation where the door moves on its hinges to allow it to open and close.
Trim the bottom Edge and Seal the Joints
Trim any excess insulation that may be overhanging the bottom edge or sides.
Tape all edges
Tape and seal all joints in the material with aluminium tape.
…. And that’s it. You’re finished!